What is Design-Cast 66?

DESIGN-CAST 66 is a two-part mix used for:

• DIRECT MODELING OF FINAL SCULPTURE, usually reinforced by fiberglass and built up over Styrofoam^® or a mesh-covered armature.
• Some MOLDED SCULPTURE MADE BY LAY-UP with fiberglass reinforcement, where there are vertical surfaces on which run-off might otherwise be a problem.

DC-66 is supplied as DRY MIX (part A) and a WATER-BASE POLYMER (part B). Part A contains hydraulic binders which harden when mixed with part B and additional water. The dry mix is a complex calcium alumino-silicate, and the polymer is an acrylic emulsion.