Design-Cast 62 is recommended for thin-shell castings, such as reliefs, plaques, full-round sculpture, architectural shapes and mold solid castings. Detailed information about Design-Cast 62 is available here.

Design-Cast 66 is recommended for direct modeling of final sculpture usually reinforced by fiberglass and built up over a Styrofoam^® or steel-mesh covered armature. It is also recommended for some molded sculpture made by lay-up with fiberglass reinforcement, where there are vertical surfaces on which run-off might otherwise be a problem. Detailed information about Design-Cast 66 is available here.

Sealers AA-6 (matte) and AA-7 (gloss) can be applied as a clear, non-yellowing, removable coating that protects completed Design-Cast works from salt spray, acidic air pollutants, weather erosion, oils, grease, alcohols, and other damaging materials. In addition, they can also be used as patina vehicles for a variety of weather-stable pigments. Detailed information about both sealers can be found here.

Retarder MC is used to extend the working time of either Design-Cast 62 or Design-Cast 66. This is particularly useful when working in hot weather, because heat will normally reduce the working time of both materials. Detailed information about Retarder MC is available here.